Radionics FDX
The AES Model 7450-RAD Subscriber connects to a Radionics alarm panel via a Radionics D9133 Serial Interface Module.
A Radionics D9133 Serial Interface Module is required to connect to the Radionics panel.
An AES 13-0344E serial cable is required to connect the D9133's dB9 male connector to the J1 programming jack of a 7450-RAD.
The Radionics alarm panel must have firmware version 2.60 or higher and be specially programmed to utilize this interface.
The Radionics messages will be translated into an Ademco CID message to utilize an existing packet type in the IntelliNet system.
